These instructions are not intended to show product recommendations for specific service. They are issued as an aid in determining correct surface preparation and application procedures. It is assumed that the proper product recommendations have been made. These instructions should be followed closely to obtain the maximum service from the product

Generic Type: Natural Resin Emulsion

It can be applied by spray, brush or roller to metal, steel and plaster. It is compatible with most existing coatings and tightly adhearing rust

Features Include:

• Quick drying - overcoat 30 - 60 minutes
• Excellent flexibility - will never harden
• Ultra violet and weather resistant proof.- been tested for 70,000 hours
• Excellent abrasion resistance
• Rust prevention
• Colour fastness
• Voc contents (Volatile Organic) 0.61 LBS/Gallon exceeding the USA maximum   Federal Standard by 90%.
• Zero flame spread

Recommended Use:

Exterior walls, interior walls, structural steel, piping, tank frames, railcars, corrugated iron, off-shore oil and gas stations, boats, wood, asbestos, glass, copper, glass fibre and aluminum

Excellent Resistance To:

Acids, alkalies, water, salt solutions and solvents

Temperature Resistance:

Minus 50c - 210°c at 110 c
Loss of gloss is observed and discolouration takes place, without loss of film integrity

Application:

Suitably prepared concrete, metal and any surface as recommended

Compatible Coatings:

To most coatings, a test patch is recommended before use. Contact your Self-Coat Dealer for specific information

Specification Data:

Volatile Organic Content as supplied - 17 Gms/Litre

Recommended dry film thickness per coat:

Steel: Dft to micrometer WFT 140 - micrometer
Concrete: DFT 60 micrometer WFT 120
Maximum DFT 80 WFT 160

Application:

By brush, roller spray (conventional or airless)
Stir contents thoroughly prior to application
Clean equipment with water prior to touch dry state

Surface Preparation:

Previously painted surfaces must be cleaned by removing grease, fat, oil, loose paint and friable dirt and paint. Enamel or solvent borne paint surfaces should be sanded to a mat finish, using Self-Bind and sandpaper. Chalked PVA and distemper
surfaces to be hosed down with water, and then be sealed with Self-Bind as soon as the tear drops has disappeared. All surfaces must be prepared by using Metal Guard, or Self-Bind Primers prior to all applications.
For further details contact the local Self-Coat Dealer

Drying Time:

At 2CPc for 25 micrometer coating and RH < 75%

Touch dry - 20 - 30 minutes
Over Coat - 30 - 90 minutes
Normal Service - 16 hours

Technical Data

* Note Some data will vary according to colour

Theoretical Spreading Rate:

12M / Litre at 25 micrometers DFT
The theoretical spreading rate stated here is for a DFT of 25 micrometers on a smooth surface for reasons of convenience and comparison.
The practical spreading rate must be calculated by the user

Notes:

1. The recommendation contained in this data sheet are based on results obtained from tests and experience. It is believed to be reliable, but is given as a guide only.

2. No guarantee is implied by the recommendations contained herein since conditions of use, method of application and preparation of the substrate prior to painting are beyond our control.

3.Our technical section should be contacted to clarify recommendations and specifications for projects, either of a specific of general nature.